MAINTENANCE
7-93
Replace Coolant Filter
--- every 500 hours
Check the DCA4 concentration every 500 hours. (Refer
to page 7-85 for the checking procedure.) If the concen-
tration is lower than the acceptable range, and if the
coolant filter has to be replaced as a result (Refer to
“Concentration Check Table” section on page 7-88.), re-
place the WF-2076 coolant filter, following the procedure
below:
WARNING: Do not attempt to loosen coolant filter
(1) until the engine is cool.
IMPORTANT: • Be sure to prepare a container large
enough to collect coolant when re-
placing water filter to avoid ground
contamination and for safety.
• Be sure to tighten the filter by hand.
If any tools are used for tightening,
breakage or deformation of the filter
head may arise. For details other
than filter replacement intervals, re-
fer to the manual for Cummins En-
gine.
1. Move shut-off valves knob (2) to the OFF position.
2. Remove filters (1) and discard it.
3. Apply a thin film of lubricating oil to the gasket sealing
surface prior to installing new filters (1).
4. Position new filters (1) to the filter head.
Tighten until the seal touches the filter head; tighten
an additional one-half to three-fourths turn.
5. Move shut-off valves knob (2) back to the ON posi-
tion.
M18M-07-048
M117-07-018
1
2
1
Summary of Contents for EX 3600-6
