MAINTENANCE
7-31
Swing Bearing --- every 250 hours
(Grouped Grease Fittings --- Main Frame)
NOTE: Auto-lubrication can be used for the fittings on
the swing bearing.
WARNING: Lubricating both the swing bearing
and gear and rotating the upperstructure must be
done by one person. Before you lubricate the
swing bearing, clear the area of all persons.
Each time you leave the cab
•
Lower the bucket to the ground.
•
Pull the pilot control shut-off lever to the LOCK
position.
•
Use handrails.
1. Park the machine on a level surface.
2. Lower the bucket to the ground.
3. Pull the pilot control shut-off lever to the LOCK
position.
4. With the upperstructure stationary, apply grease to
the twenty-four grease fittings.
5. Raise the bucket several inches off the ground and
rotate the upperstructure 45
°
(1/8 turn).
6. Lower the bucket to the ground.
7. Repeat the procedure three times, beginning with
step 3.
8. Apply grease to the swing bearing until grease can be
seen escaping from the swing bearing seals.
9. Total amount of grease to be applied is approximately
10 to 12 strokes by grease lubricator.
10. Take care not to supply excessive grease.
M18M-07-029
Summary of Contents for EX 3600-6
