MAINTENANCE
7-40
17. Remove oil filler cap (4) and fill with 260 liter (68.7 US
gal) oil.
18. Confirm oil level and adjust the oil level to be the
center of the marks static H and L on dipstick (5).
Start the engine and run at slow idle speed for 5
minutes. Stop the engine after confirming that engine
oil pressure is rising. Ten to twenty minutes later,
check oil level again and add oil if necessary.
IMPORTANT: After one shift, the oil level check must
be done if oil level is the center of the
marks static H and L.
NOTE: Checking the oil level immediately after shut
down will result in inaccurate readings. Be sure
to allow the oil to settle for at least 10 minutes
before checking.
NOTE: Oil can be refilled from the ground using the
Fast-Filling panel located in the rear of the base
machine. Refer to page 1-38 for the Fast-Filling
panel operation.
Change Engine Oil in Reserve Tank
--- every 500 hours
(first time after 50 hours)
1. Run the engine to warm oil. DO NOT run the engine
until oil is hot.
2. Park the machine on a level surface.
3. Lower the bucket to the ground.
4. Turn the auto-idle switch off.
IMPORTANT: The turbocharger may be damaged if the
engine is not properly shut down.
5. Run the engine at slow idle speed without load for 5
minutes.
6. Stop the engine. Remove the key from the key switch.
7. Pull the pilot control shut-off lever to the LOCK
position.
WARNING: Engine oil may be hot just after
operation. Use care to be sure you are not burned
from hot oil.
M18M-07-075
4
5
Summary of Contents for EX 3600-6
