Heyer iTernIS ADV, Operator'S Manual

Page: 198 / 218

Technical specifications| iTernIS ADV
17. 8
17.11.2 | Manufacturer
Statement:
Electromagnetic Immunity
Table 17-11 Electromagnetic Emissions Statement
iTernIS ADV is intended to be used in the specified electromagnetic environ -
ment. The customer and/or user of iTernIS ADV must ensure it is used in an
electromagnetic environment as stated in this Table.
Emission Test Compliance Electromagnetic Environment
RF CISPR 11
Emissions
Group 1
iTernIS ADV uses RF energy only for its
internal operations. Therefore, its RF emis-
sions are very low and they are unlikely to
cause any interference in nearby electronic
equipment.
RF CISPR 11
Emissions
Class A
iTernIS ADV can be used in all establish-
ments, except in households, and those that
are connected directly to the public low vol-
tage power supply network feeding buildings
used for domestic purposes.
IEC 61000-3-2
harmonic emis-
sions
Class A
IEC 61000-
3-3 Voltage
fluctuations /
discontinuous
emissions
According to
specifications
Table 17-12 Electromagnetic immunity Statement
iTernIS ADV is intended to be used in the electromagnetic specified environ -
ment. The customer and/or user of iTernIS ADV must ensure it is used in an
electromagnetic environment as stated in this Table.
Immunity test
IEC 60601-1-2
Test level
Compliance
level
Electromagnetic
environment
IEC 610000-4-
4 Electrosta-
tic Discharge
(ESD)
Contact: ± 6 kV.
Air: ± 8 kV.
Contact: ± 6 kV.
Air: ± 8 kV.
Floors must be
wood, concrete, or
ceramic. If floors are
covered with synthetic
material, the relative
humidity must be at
least 30%.
IEC 61000-4-4
Fast electrical
transient in
bursts
± 2 kV for power
lines.
± 1 kV for input/
output lines.
± 2 kV for power
lines.
± 1 kV for input/
output lines.
The quality of the
electrical network must
be equivalent to that of
a typical commercial or
hospital environment.
IEC 61000-4-5
Shock waves
Differential mode:
±1 kV.
Shared mode: ±
2 kV.
Differential mode:
±1 kV.
Shared mode: ±
2 kV.
The quality of the
electrical network must
be equivalent to that of
a typical commercial or
hospital environment.
IEC 61000-
4-11 Voltage
dips, short
interruptions
and voltage
variations on
line power
input
< 5% UT (low >
95% of UT) for 0.5
cycles.
40% UT (low of
60% of UT) for 5
cycles.
70% UT (low of
30% of UT) for 25
cycles.
< 5% UT (low >
95% of UT) for 5 s.
< 5% UT (low >
95% of UT) for 0.5
cycles.
40% UT (low of
60% of UT) for 5
cycles.
70% UT (low of
30% of UT) for 25
cycles.
< 5% UT (low >
95% of UT) for 5 s.
The quality of the
electrical network must
be equivalent to that of
a typical commercial or
hospital environment.
If the user of iTernIS
ADV requires maintai-
ning operation during
power outages, we
recommend connecting
the system to an unin-
terrupted power supply
or a battery.
17.11.1 | Manufacturer
Statement:
Electromagnetic Emissions