Hewlett Packard Enterprise HPE ProLiant XL170r Gen10, Maintenance And Service Manual

Page: 42 / 129

Procedure
1. Power down the server.
2. Disconnect all peripheral cables from the server.
3. Remove the server from the chassis.
4. Remove the air baffle.
5. Remove the bayonet board.
6. Separate the small bayonet boards from the large bayonet board.
To replace the component, reverse the removal procedure.
Removing and replacing an expansion board
CAUTION: Before replacing a DIMM, expansion board, or other similar PCA components due to a perceived
hardware error, make sure first that the component is firmly seated in the slot. Do not bend or flex circuit boards
when reseating components.
Prerequisites
Before you perform this procedure, make sure that you have a T-10 and T-15 Torx screwdrivers available.
Procedure
1. Power down the server.
2. Disconnect all peripheral cables from the server.
3. Remove the server from the chassis.
4. If a secondary PCIe riser cage is installed, remove the bayonet board.
5. If replacing the expansion board installed in slot 1, do one of the following:
42
Removal and replacement procedures