31
*NOTE: It is advisable, for testing purposes, to temporarily run a new Ethernet cable
above ground directly from the router to the MSP (THIS IS FOR TESTING PURPOSES
ONLY). Use an off-the-shelf cable OR a fully verified cable.
First, identify a port on the router that remains active,
temporarily disconnect the Ethernet cable
*
, and plug a
temporary patch cable in. Plug the cable into the MSP.
IF the router’s LEDs are still not active, replace the MSP
(
HLX-LOC-DSP
). IF active go to step 1H.
On the MSP, verify that at least one LED is active. When
both LEDs are active it confirms a connection is made
AND data is being transferred back and forth. IF LEDs
are ON, go to step 1I. IF NOT, replace MSP:
(
HLX-LOC-DSP
).
Plug into an active router port
Inspect MSP’s Ethernet port
WARNING: Prior to disconnecting any other cables from the router, first note the cable and its
position. ALWAYS get permission to disconnect cables as this can affect the devices’ operation.
Step 1G
Step 1H
1. Wired Ethernet: “MSP Not Found” (cont.)
