Hardi HC 9600, Operator'S Manual

Page: 18 / 212

3 - Description
16
Initial Start-up
General info
An Initial Setup wizard is presented on start-up. The wizard is presented if the display is brand new out-of-the-box.
÷
NOTE! Not all of the following parts may be required to follow - it depends on your specific setup.
Once the wizard is completed, it is not shown again unless the display memory is cleared.
Initial Setup Wizard
The Initial Setup wizard will take you through the following setup items:
Time\Date, Time Zone, Unit System, Language
• Advanced Options. See “Advanced Options” on page 35.
• Restore Backup.
• Upgrade Firmware.
• Unlock Display Features.
Single or Multiple Display Setup
• Single
Use single display if this is the only display that is getting setup.
• Multiple Display
Use multiple display if there is more than one display in the operation and the plan is to share management data
between displays. After initial setup is complete, enter management information and create an .agsetup file.
÷
NOTE! Using the Restore backup option is not the proper method to get multiple displays set up to be the same. Use
the .agsetup file.
It is acceptable to complete the Initial Setup wizard and then upgrade. Setup information will not change.
• On a “clean” display going out for service, to stand in for a failed display, the customer should use the Restore backup
option in the Initial Setup wizard.
μ
ATTENTION! The business created on the first display, and any other management and equipment items, will be
imported to the additional displays.