Hardi HC 9600, Operator'S Manual

Page: 125 / 212

4 - System setup
123
Equipment Settings
OR
Rate Outside of Field
This setting will define how product will be
controlled when leaving a field boundary.
• Zero
This will stop application.
• Last Good
This will continue application at the last
known rate.
• Rx Default
When using a prescription, this will apply at
the Default Rate (or outside of boundary
rate) as defined by the prescription file.
Rate Display Smoothing
Determines how the feedback from the control
channel rate sensor will be displayed on the map
screen.
• De-selected
The system will display raw feedback from the rate sensor.
• Checked
The system will display target rate when the application rate is within 10% of the target rate setting.
Rate Change Look-Ahead
This setting compensates for any latency in the control system when changing between different product flow rates during
variable rate application.
The typical setting range for this is 0-1 seconds.
This setting can be thought of as a “look ahead” value when using a variable rate prescription. The display will send the signal
to change rates before hitting a transition line so that the applied rate is correct when crossing into the new management
zone.
Configuration
Select Your Specific
Configuration
Equipment Settings
Settings
Configuration Settings Equipment Settings
Equipment Configuration Settings
Rate Change
Look-Ahead
Rate Outside of Field
Zero
Rate Display Smoothing