K-BUS
KNX/EIB 3.5/5.0/10.1 inch Touch Panel Plus
75
○
R
This parameter is used to set the logic operation value which will be sent to the bus,when the input threshold
is less than,equal to,not equal to,more than,no more than,no less than the preset value.The options:
Do not send telegram
Send value “0”
Send value “1”
Do not send telegram: The object value is ignored.
Send value “0”/“1”:Send value 0 or 1 to the bus.
If there is conflict between each setting,the logic value will be sent according to the last condition.
For example:parameter“If Object value=Threshold value”,Set Send value “0”
，
Parameter“If Object value<=Threshold value”,Set Send value “1”
，
When the object is equals to the threshold value,the logic operation result 1 will be sent to the bus.
Parameter“Output send when”
This parameter is used to set the condition of sending the logic operation result.The options:
Receiving a new telegram
Every change of output object
Receiving a new telegram:when a new logic input value is received,the logic operation result will always be
sent to the bus.
Every change of output object:When the logic operation result changes,it will be sent to the bus.
Parameter“Send delay time”
Base:
None
0.1s
1s
...
25s
Factor:
1..255
This parameter is used to set the delay time of the logic operation result sending to the bus. Delay=Base x
Factor,for example,when the base is “None”,there is no delay.
Note:
Although the logic operation result is not changed when doing the first logic operation,it also will
be sent to the bus.
