K-BUS
KNX/EIB 3.5/5.0/10.1 inch Touch Panel Plus
29
○
R
panel into the screen saver mode. Available Options: 0..255
Parameter“Password function ”
To set whether to enable the password protection function, that is, whether to enter the password when
re-operate the screen after the screen saver mode or screen is turned off. Options:
Disable
Enable
——Parameter“Password (only digit number allow)”
This parameter sets the password and it only supports 4 digit passwords.
Parameter“Status object read request after restart”
To set whether the device sends a status request telegram when the device starts. Options:
Disable
Enable
This parameter applies to switch state feedback, dimming state feedback, curtain position feedback, air
quality detection display, and outdoor temperature detection on the function page.
After being enabled, when the device starts up or the bus is powered on again,it will send telegram to the
bus to read the value of temperature, humidity, CO2, PM2.5 etc. detected by the sensor.
After being enabled, when the device starts up or the bus is powered on again, it will send telegram to the
bus to read brightness value status of switching or dimming.
After being enabled, when the device starts up or the bus is powered on again, it will send telegram to the
bus to read curtain position status.
Parameter“Page title up to 15 characters or 5 Chinese characters”
Parameter“Icon name up to 9 characters or 4 Chinese characters”
Note:
The page title of the screen can display up to 15 characters or 5 Chinese characters.
The icon name can display up to 9 characters or 4 Chinese characters.
*mark that the function applies to different device versions
The parameter or parameter option function with asterisk * only supports certain devices and does not apply
to all versions of the screen.