K-BUS
KNX/EIB 3.5/5.0/10.1 inch Touch Panel Plus
24
○
R
②
CO2 concentration
The value is displayed according to the received value with range 0 to 4000 ppm. If the value is above
4000ppm, showing only 4000ppm.
③
PM2.5 concentration
The value is displayed according to the received value with range 0
～
999ug/m3. If the value is above
999ug/m3, showing only 999ug/m.
④
Hot swap on status
When the icon is bright, it indicates that hot swap is on. When the icon is dark,it indicates that hot swap is off.
The default setting is to enable the hot swap function when you turn on the power. Touch this icon to control the
on/off of hot swap. You can also control the on and off status by writing the value to the object Heat Recovery.
When the object En./Dis. is disabled, the function cannot be enabled by touch/telegram.
⑤
Filter life
It is used to indicate the filter remaining life value. Touching this icon will pop up the interface as shown in
Figure 5.9.2:
Figure 5.9_2
Selecting
will reset the filter life value to 100%. Selecting
to return to the function page. The
lifetime value of the filter can be modified by the object.
⑥
Wind Speed
Touch this icon, the wind speed will be switched from the current wind speed level by 1... AUTO...1 cycle.
When switching to wind speeds 1, 2 and 3, switching takes effect immediately. When “3” is switched to “AUTO”, if
there is no new wind speed control operation within 3 seconds, the wind speed will switch to automatic mode
after 3 seconds.
In automatic mode, no specific wind speed is displayed, only the automatic icon is bright. In manual mode,
the wind speed status can be updated by the object.
⑦
Room Temperature
It is used to display the room temperature. The value is updated by object (external temperature sensor) or
the temperature detected by the built-in sensor.You can select to display either Celsius (°C) or Fahrenheit (°F) to
according to the parameter setting “Temperature display units” of database on ETS.
