GRAUPNER mx-16 ifs, Programming Manual

Page: 123 / 132

123 Trainer system
Checking the functions
Operate the assigned Trainer change-over switch:
The Pupil system is working properly if no error •
message appears in the basic display of the Teacher
transmitter when you operate the assigned change-
over switch.
However, if the basic display shows the message
•
n o
s t u d e n t
s i g n a l
,
then there is a problem with the connection; at the
same time you will hear a warning signal. In this
case all the functions remain under the control of the
Teacher transmitter, regardless of the position of the
Trainer change-over switch. This ensures that the
model is not uncontrollable at any time.
Important note:
It is absolutely essential to check that all functions can
be transferred correctly BEFORE you start using a
Trainer mode system.
Possible errors
The iFS receiver is not bound to the Teacher trans- •
mitter.
The interface in the Pupil transmitter, which replaces
•
the RF module, is not connected correctly.
The Pupil transmitter is not ready for use.
•
The Pupil transmitter is not set to PPM mode. •
The Trainer lead is not properly connected. •