GRAUPNER mx-16 ifs, Programming Manual

Page: 126 / 132

126 Approved transmitter output stages and national receiver settings
Approved transmitter output stages and national receiver settings
In order to fulfi l various directives including FCC, ETSI, IC etc., and other statutory regulations valid in individual countries, this radio control system is only approved for use with
the transmitter output stages and national receiver settings stated below. Please observe the legal restrictions which apply to you. It is prohibited to use the radio control system
with settings other than those stated below.
Keine Haftung für Druckfehler! Änderungen vorbehalten!
Liability for printing errors excluded! We reserve the right to
introduce modifi cations!
Nous ne sommes pas responsables d’éventuelles erreurs
d’impression! Sous réserve de modifi cations!
Nessuna responsabilità per errori di stampa! Ci riserviamo la
facoltà di apportare cambiamenti!
Approved transmitter output stages
The output stages stated in the table below MUST be
observed, otherwise the system will not satisfy the statu-
tory regulations which apply in your country.
Country Approved settings
North America and
Australia Hopping mode 1 … 3
Output stages 1 … 5
Japan and Europe Hopping mode 1:
Output stages 1 … 2
Hopping mode 4 + 5:
Output stages 1 … 5
These settings are carried out using the methods
described in the section starting on page 22.
Approved national receiver settings
The national setting is required in order to fulfi l various
directives such as FCC, ETSI, IC etc..
Note:
This setting refers exclusively to Hopping Mode 1; it is
not applicable to any other Hopping Mode.
Country Setting
All countries except France 1
France 2*
* Open-air operation. Transmitter output “1” must be selected.
These settings must be carried out using the methods
described in the section starting on page 24, and in the
instructions supplied with the receiver.