GRAUPNER mx-16 ifs, Programming Manual

Page: 49 / 132

49 Program description: basic settings – fi xed-wing model
Phase 2 / Phase 3
phase 3
train./stu.
phase 2
1QR
takeoff
SEL
speed
C2
10:01
clock
When you select “phase 2” and / or “phase 3”, you
will see
SEL at the bottom edge of the screen. Press
ENTER or the rotary cylinder, and the current setting is
shown highlighted. If you do not wish to use the default
names, use the rotary cylinder to select a suitable name
from the pre-sets. Press the rotary cylinder to return to
the function line.
Move to the switch symbol
using the rotary cylin-
der, then press the rotary cylinder again briefl y. A switch
can be assigned to the fl ight phase as described on
page 33.
For more information on fl ight phase programming
please refer to page 70, in the section entitled »
Phase
trim «.
Trainer / student
phase 3
train./stu.
phase 2
1QR
takeoff
SEL
speed
C2 10:01 clock
In this menu line you can assign a “transfer switch” for
Trainer (teacher / pupil) mode operations, after pressing
the rotary cylinder or
ENTER , as described on page 33.
The switch is used to transfer control from one transmit-
ter to the other.
For more information on Trainer systems please refer to
page 122.
Receiver output
For maximum fl exibility in terms of receiver socket as-
signment, the
mx
-16iFS software provides the means
to swap over the servo outputs 1 to max. 8; this is
carried out on the second page of the “Receiver output”
sub-menu.
phase 3
train./stu.
phase 2
1QR
takeoff
SEL
speed
receiv out
Press the rotary cylinder or the ENTER button to move
to the next page of the display. Here you can assign
the “control channels” for servos 1 … 8 to any receiver
output you wish to use. However, please note that the
display in »
servo display « – which you can reach by
pressing the rotary cylinder from the basic display – re-
fers exclusively to the “control channels”, i. e. the outputs
are
not swapped over.
S
S
S
S 1
2
3
4 1
2
3
4 output
output
output
output
SEL
With the rotary cylinder held pressed in, select the servo
/ output combination you wish to change, then press
ENTER or the rotary cylinder. Now you can assign the
desired servo(s) to the selected output using the rotary
cylinder … or alternatively press
CLEAR to revert to the
default sequence.
Please note that any subsequent changes to servo
settings, such as servo travel, Dual Rate / Expo, mixers
etc.,
must be carried out according to the original
(default) receiver socket sequence .
Note:
It is also possible to swap over the outputs of XR-series
receivers at the receiver itself, as described on page 26
and in the instructions supplied with the actual receiver.
However, we strongly recommend that you use only one
of the two options, as a combination will soon lead to
confusion.
Typical applications:
If you wish to use a smaller receiver with six or even •
just four servo sockets, it may be necessary to re-as-
sign the receiver sockets in order to be able to oper-
ate a second camber-changing fl ap, a second aileron
servo or a speed controller.
It may also prove necessary to swap servos for Trai-
•
ner mode operations, if you are using a model set up
for another make of equipment fi tted with a Graup-
ner | iFS RF module, to avoid having to re-connect
the servos at the receiver.