GRAUPNER mx-16 ifs, Programming Manual

Page: 37 / 132

37 Fixed-wing models: receiver assignment
3 = Elevator / left V-tail
2 = Aileron / left aileron
8 = 2nd elevator / aux. function
7 = Right fl ap / reserve
5 = Right aileron / reserve
4 = Rudder / right V-tail
1 = Throttle / brake
Installation notes
The servos MUST be connected to the receiver
outputs in the following order:
Outputs not required are simply left vacant. Please note
the following points in particular:
If you are using only one aileron servo, receiver •
output 5 (right aileron) is left unused; it can also be
used for another purpose if you select “1 aile” in the
»
base sett. « menu.
If you are using only one fl ap servo, receiver output 7 •
(right fl ap) MUST be left unused, assuming that you
have selected “2 ail
2 fl ” in the » base sett. « menu.
If you are using a GRAUPNER transmitter to control a
model which was formerly fl own using a different make
of transmitter fi tted with a
Graupner | iFS RF module,
e. g. when using the
mx
-16iFS for Trainer mode op-
erations, it may be necessary to re-arrange the servo
sequence at the receiver outputs as shown in the
diagram on the left. However, an alternative method is
to use the “receiv(er) out(put)” sub-menu of the
» base
sett. « menu; see page 49. Different methods of install-
ing servos and control linkages may make it necessary
to reverse the direction of rotation of some servos when
programming. In both cases this is carried out in the
»
servo set. « menu; see page 56.
Please also read the information on the following
pages.
6 = Flap / left fl ap / reserve
Receiver socket assignment for models with up to two ailerons and two fl aps, plus “normal” tail type, V-tail,
and two elevator servos (3 + 8)
Ser
v
o
4,
8 V
C 57
7
B
es
t.-
N
r. 4101
7
6
5
4
3
2
1
8/
Batt
.
PLL-Synthesizer-MICRO-SUPERHET
Best.-Nr.
7052
Kanal 60-282/182-191
für das 35MHz/35MHz-B-Band
SCAN
LED
Made in Malaysia
FM
Receiver battery
Switch harness