General Information
Applicable to all Model Types
5
The installation of the module is performed as
described in the MC-18 programming manual.
IMPORTANT
After installation of the module ALL model memories
should be cleared. If this is not done, it is possible
that fragments of previous programs left in the
memory may cause malfunction in conjunction with
the PROFI-ULTRASOFT-Module.
To this end, after selecting the model No via code 56
ENTER
, entering the model number 1…7 (or
1…30
1
), the key
CLEAR
has to be pressed first
instead of just pressing the
ENTER
, and
ENTER
is
then used to clear the memories. This step should
preferably be performed immediately after installation
of the module for ALL model memories, one after
another.
Therefore input as follows:
ENTER
5
6
ENTER
1
CLEAR
ENTER
ENTER
5
6
ENTER
2
CLEAR
ENTER
…
ENTER
5
6
ENTER
7
CLEAR
ENTER
(…
ENTER
5
6
ENTER
3
0
CLEAR
ENTER
)
This procedure needs only to be performed this one
time.
List of Functions
The PROFI-ULTRASOFT-Module has nine different
model types in all, which are selectable via code 58.
For obvious reasons model selection must be the first
step when programming a new model. This step
determines which of the options will be available in
the course of the programming process.
1
TX of series ’89 (and later) are designed for 30 model memories.
Basic Programs including Automatic Manoeuvres
MULTISOFT for Aerobatic classes such as F3A and F3B
Code Model Type
58/1
NORMAL
Normal Model
/2
NORMAL/DIFF
Normal models with 2 Aileron Se rvos
/3
DELTA/DIFF
Delta and Flying Wing models
/4
UNIFLY/DIFF
For sailplanes & power models equipped with
plain flaps or spoilers actuated by a single servo.
/5
QUADRO-FLAP
For sailplanes & power models equipped with
separate servos for each aileron an d each flap (4
wing mounted servos).
Universal Profi-Programs
For competition pilots in classes F3A, F3B, F3E & large soarers.
58/6
F3B (3 wing-sv)
Universal program for contest models equipped
with 3 wing mounted servos.
(1 servo for flaps); undesired functions to be left
unoccupied at the RX.
/7
F3B (4 wing-sv)
Universal program for contest models equipped
with 4 wing mounted servos.
(2 servos for flaps); undesired functions to be left
unoccupied at the RX.
Universal Helicopter Programs
For contest flyers in class F3C
58/8
HELI
Universal program for contest models including
those equipped with rpm and gyro control.
/9
HELI (sp.ctl)
Special program for contest models equipped
with gyro and rpm control.
Summary of Contents for mc-18
