GOLDONI 26RS, Operation And Maintenance

Page: 102 / 200

101
5.7.8 Mudguard adjustment (for Mod. SN-A)
Front mudguards:
The internal measurement between the mudguards can be adjusted. The
obtainable measurements are (position E fig.1) E=460mm; 500mm; 540mm.
This width adjustment is obtained by unscrewing the fixing screws A fig. 1 (in
position E=540mm, the two brake and clutch pedal boards can be moved
outwards by unscrewing the screws that fix them to the pedal rods).
Rear mudguards:
The internal measurement between the mudguards can be adjusted. The
obtainable measurements are (position F fig.1) F=500mm; 540mm. This width
adjustment is obtained by unscrewing the fixing screws C fig.1 and loosening
the screws of guards D fig.1.
Do not use position F=460mm even if this is possible.
This is not an approved position as it no longer ensures safety
distances between moving parts.
5.8 ELECTRICAL SYSTEM
- Battery
Check and maintain the level of the electrolyte so that it covers the battery
elements, adding distilled water with the engine off and well away from naked
flames. Make sure that the battery terminals are well fixed and keep them
lubricated with Vaseline grease. Keep the battery clean and store it in a dry
place if it is to remain unused for a long period of time.
- Clogging gauge of the engine air filter
Check that the clogging gauge of the engine air filter is in the correct position
and, if it is serviced, make sure that it is correctly assembled and protected
against the outdoor weather conditions as indicated in fig. 26.
It is essential for the cable connecting to the electrical system of the machine N°
1 fig. 26 to come out of the lower part of the actual gauge itself. The engine air
intake circuit could be seriously damaged if the protection is installed in the
wrong position.