GOLDONI 26RS, Operation And Maintenance

Page: 101 / 200

100
5.7.1 Adjusting the clutch cable
When the free travel of the pedal is less than 10 mm, it must be regulated by
means of adjuster n.1 fig.21 mod.30SN-30A-40SN-40A, n.1 fig.27 mod.W40RS-
40R-W45RS-45R-45RS.
5.7.2 Adjusting the main and parking brake
Lengthen rod 1 fig. 12 if one of the two rear wheels brakes differently to the
other or if there are differences in the free travel of the main brakes (N° 3 fig. 1)
or emergency – parking brake lever (N° 6 fig. 1).
This adjustment should be carried out separately on both wheels.
For mod. 30SN-30A-40SN-40A, loosen nut N°2 fig.24 and operate on sleeve N°
1 fig.24, then lock in place with nut N°2 fig.24.
5.7.3 Adjusting the accelerator cables
To adjust the travel of the hand lever, use the adjuster screw behind the lever
itself.
The accelerator pedal cables are adjuster by means of the adjuster screws on
the engine end of the cables themselves.
5.7.4 Adjusting the motor stop cable
Use the adjuster screw on the engine end of the cable if the travel of the motor
stop knob is excessive.
5.7.5 Adjusting the front wheel toe-in (Mod. RS-R)
The front wheel toe-in is correct when it complies with the measurements in fig.
14.
5.7.6 Adjusting the soil scraper blades (for Mod.26RS-30RS)
The tractor is equipped with soil scraper blades on the 4 mudguards, that can be
adjusted according to the selected track width (N° 2 fig.1).
The front and rear blades can be positioned as indicated in fig.5.
Important:
The distance between blade and cover must not be less than 5mm.
5.7.7 Adjusting the front mudguards (for Mod.26RS-30RS)
Adjust the front mudguards depending on the selected track width, moving
spacers N° 2 fig.7 Mod.26-30 as required.