GOLDONI 26RS, Operation And Maintenance, Page: 95 / 200

94
Controls:
- P
Allows the height of the implement to be set at the desired position.
Lower lever A to position 1, turn potentiometer P until reaching the point in
which the implement has moved to the required position. Turn towards the
minus sign (-) to lower the implement; turn towards the plug sign (+) to raise
the implement. After having regulated the position, operate the power lift with
lever A. When it lowers, the implement will set to the previously adjusted
height.
- S Fully turned to the minus (-) position.
- A:
Position 0 – Lever in the intermediate position. The power lift will be in the
neutral position and the implement will remain at a standstill in the position it
has reached.
Position 1 – Lever down. The implement lowers until it reaches the
previously selected height setting.
Position 2 – Lever up. Keep the lever up until the desired height has been
reached. The lever will return to the neutral position 0 when released.
4.9.2.3 Draft control
This operating mode is suitable for work that requires a constant tractive force,
preventing the engine from being overloaded and reducing wheel slip
(mouldboard ploughs, disc ploughs, harrows, cultivators of all types, etc.)
Controls:
- P
Fully turned to the minus (-) position.
- S Allows the work depth to be regulated according to the tractive force
required to bring and keep the tractor to the limit before wheel slip. Move
lever (A) down to position 1, turn potentiometer S until reaching the point in
which the implement has moved to the desired position, always within the
limit of tractor wheel grip. Turn towards the plus sign (+) to reduce the draft
and limit the work depth; turn towards the minus sign (-) to increase draft as
the work depth increases. After having adjusted for draft, operate the power
lift with lever A. The implement will position according to the draft setting.
- A:
Position 0 – Lever in the intermediate position. The power lift will be in the
neutral position and the implement will remain at a standstill in the position it
has reached.
Position 1 – Lever down. The implement will lower until it reaches the
previously selected draft setting.
Position 2 – Lever up. Keep the lever up until the desired height has been
reached. The lever will return to the neutral position 0 when released.