PART THREE - OPERATION
SECTION 6 - TEST/MAINTENANCE
Model F53 Flow Monitor/Totalizer (universal-mount 1/2 DIN)
Rev. 1-201
72
6.2 RESET VOL
(A, B, C, and D)
6.3 HOLD OUTPUTS
☞
You can manually reset a totalizer volume to zero at any
time, even when that totalizer is set for the “AUTO RESET”
mode.
These instructions reset VOL A. Reset other vol-
umes in the same way using their respective menu
screens.
1.
With the
top-level menu screen dis-
played, use
Ø
Ø
key
to select the “RESET VOL A” line.
2.
Press
ENTER key
to display “RESET VOL A: ARE YOU
SURE?” screen.
3.
To reset Sensor A volume to zero, press
ENTER key
again (“VOL A RESET: DONE” screen appears, ac-
knowledging reset has occurred).
4.
To return to the TEST/MAINT top-level menu screen,
press
ESC key
or
ENTER key
.
The analyzer has a convenient feature to hold both analog
outputs (1 and 2) at their last measured values for up to 30
minutes, suspending operation of any connected devices.
1.
With the TEST/MAINT top-level menu screen dis-
played, use
Ø
Ø
key
to select “HOLD OUTPUTS” line.
2.
Press
ENTER key
to immediately hold the analog
outputs (“HOLD OUTPUTS” screen appears, acknowl-
edging that hold has occurred).
NOTE:
If the keypad is not used within 30 minutes, the
analog outputs will automatically change back
to their active states and the display will return
to the MEASURE screen.
3.
To end hold at any time and return the analog outputs
back to their “active” states, press
ENTER key
(display
returns to TEST/MAINT top-level menu screen).
