PART THREE - OPERATION
SECTION 3 - CONFIGURING THE ANALYZER
Model F53 Flow Monitor/Totalizer (universal-mount 1/2 DIN)
Rev. 1-201
64
Table D -- ANALYZER CONFIGURATION SETTINGS (RANGES/CHOICES and DEFAULTS -- continued)
Displayed Screen Title
Entry Range or Choices (where applicable)
Factory Default
Your Setting
SENSOR Configuration Settings (A, B, C, and D) -- continued
SET PIPE ID?
3.000-40.00 INCHES
SET SLOPE?
0.0000-999.9999GPM/HZ
SET OFFSET?
0.0000-999.999pGPM
RESET CONFIGURE function
does not change setting which is
only replaced by a new setting.
CALCULATION Settings (any combination of two sensors; A, B, C, and D)
SET VARIABLE X?
FLOW A, FLOW B, FLOW C, FLOW D,
VOLUME A, VOLUME B, VOLUME C, or
VOLUME D
FLOW A
SET VARIABLE Y?
FLOW A, FLOW B, FLOW C, FLOW D,
VOLUME A, VOLUME B, VOLUME C, or
VOLUME D
FLOW B
SET FORMULA?
NONE, X-Y, X+Y, X/Y, or [X/Y] x 100
NONE
DISPLAY FORMAT?
X-Y or X+Y (flow variables): multiplier of
x1, x10, x100, x1000 or x10000, and
format of XXXX, XXX.X or XX.XX
X-Y or X+Y (volume variables): always
whole numbers without multiplier
X/Y: format of XXXX, XXX.X or XX.XX
[X/Y] x 100: no choice -- always in %
x1 multiplier with XXXX format
not applicable
XXXX
%
OUTPUT Configuration Settings
SET PARAMETER?
FLOW A, FLOW B, FLOW C, FLOW D,
VOLUME A, VOLUME B, VOLUME C,
VOLUME D, or CALCULATION
Output 1: FLOW A
Output 2: FLOW B
SET 4mA VALUE?
For FLOW (any sensor): depends on
selected units and display format
For VOLUME (any sensor): 0-999,999,999
with selected units
For CALCULATION: depends on selected
display format
Outputs 1 and 2: Depends on
selected units
and formats
SET 20mA VALUE?
For FLOW (any sensor): depends on
selected units and display format
For VOLUME (any sensor): 0-999,999,999
with selected units
For CALCULATION: depends on selected
display format
Outputs 1 and 2: Depends on
selected units
and formats
SET FILTER?
0-60 SECONDS
Outputs 1 and 2: 0 SECONDS
SCALE 0mA/4mA?
0mA or 4mA
Outputs 1 and 2: 4 mA
RELAY Configuration Settings
Settings Common To ALARM and CONTROL Relays:
SET PARAMETER?
FLOW A, FLOW B, FLOW C, FLOW D,
VOLUME A, VOLUME B, VOLUME C,
VOLUME D, or CALCULATION
Relay A: FLOW A
Relay B: FLOW B
Relay C: FLOW C
Relay D: FLOW D
SET FUNCTION?
ALARM, CONTROL or STATUS
Relays A, B, C, and D: ALARM
OFF DELAY?
0-300 SECONDS
0 SECONDS
ON DELAY?
0-300 SECONDS
0 SECONDS
(Table D continued on next page.)
