PART THREE - OPERATION
SECTION 4 - ANALYZER CONFIGURATION
Rev. 1-201
Model F53 Flow Monitor/Totalizer (universal-mount 1/2 DIN)
57
SET FUNCTION Mode
(alarm, control or status)
2.
Use
Ø
Ø
key
to select the “SET RELAY A” line, and press
ENTER key
to display
.
3.
With the “SET PARAMETER” line selected, press
ENTER key
to display a screen like
.
Use
Ø
Ø
and
×
×
keys
to view the choices. With the de-
sired choice displayed, press
ENTER key
to enter this
selection.
Each relay can be selected to function as a:
•
ALARM
relay (with separate high and low alarm points
and deadbands) that operates in response to the
selected measured value.
•
CONTROL
relay (with phasing, setpoint, deadband,
and overfeed timer) that operates in response to the
selected measured value.
•
STATUS
relay that is not configurable. It is a dedicated
system diagnostic-only alarm relay that automatically
energizes when the “WARNING CHECK STATUS”
message flashes on the MEASURE screen. This occurs
when the analyzer detects a sensor or analyzer “fail”
diagnostic condition (see PART THREE, Section 6.1 for
details).
1.
With the
screen displayed, use
Ø
Ø
key
to select the “SET FUNCTION” line.
2.
Press
ENTER key
to display a screen like
. Use
Ø
Ø
and
×
×
keys
to view the
choices (ALARM, CONTROL or STATUS). With the de-
sired choice displayed, press
ENTER key
to enter this
selection.
