Part No. 139378
Z-30/20N • Z-30/20N RJ • Z-34/22 • Z-34/22N
5 - 1
June 2011
Section 5 • Fault Codes
Before Troubleshooting:
Read, understand and obey the safety rules and
operating instructions in the
appropriate
operator's manual on your machine before
attempting any maintenance or repair procedure.
Be sure that all necessary tools and test
equipment are available and ready for use.
Be aware of the following hazards and follow
generally accepted safe workshop practices.
Crushing hazard. When testing
or replacing any hydraulic
component, always support
the structure and secure it
from movement.
Electrocution/burn hazard. Contact
with electrically charged circuits
could result in death or serious
injury. Remove all rings, watches
and other jewelry.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
Note: Two persons will be required to safely
perform some troubleshooting procedures.
Fault Codes
Observe and Obey:
Troubleshooting and repair procedures shall be
completed by a person trained and qualified on
the repair of this machine.
Immediately tag and remove from service a
damaged or malfunctioning machine.
Repair any machine damage or malfunction
before operating the machine.
Unless otherwise specified, perform each
repair procedure with the machine in the
following configuration:
• Machine parked on a firm, level surface
• Boom in stowed position
• Turntable rotated with the boom between
the non-steer wheels
• Key switch in the off position with the
key removed
• Wheels chocked
• All external AC power supply disconnected
from the machine
Summary of Contents for Z-30/20N
