Genie S-80, Service Manual

Page: 169 / 353

Part No. 122985 S-80 • S-85 • S-80X 5 - 3
February 2011 Section 5 • Fault Codes
FAULT CODES
Error Source Error Type Condition Solution
ID Name ID Name
21 Primary 11 Value at 5V Function is Cycle power off,
Up / Down 12 Value too high inoperative. then on after
Joystick 15 Value too low Alarm sounds problem has been
16 Value at 0V indicating a fault. corrected.
17 Not calibrated Calibrate joystick.
22 Primary 21 Fault Valve is operating Cycle power off,
Up / Down outside of limits. then on after
Directional Alarm sounds problem has been
Valves indicating a fault. correted.
23 Primary 12 Value too high Valve is operating Cycle power off,
Up / Down 15 Value too low outside of limits. then on after
Flow Valve Alarm sounds problem has been
indicating a fault. corrected.
17 Not calibrated Normal function Calibrate valve
except threshold threshold.
for one or both
directions is zero.
24 Angle sensor 11 Value at 5V Reduced speed Cycle power off,
12 Value too high function. then on after
15 Value too low Alarm sounds problem has been
16 Value at 0V indicating a fault. corrected.
17 Not calibrated Calibrate angle sensor.
31 Invalid setup
26 Angle sensor 19 Out of range
cross check
(S-80X)
Continued on next page