Genie S-80, Service Manual

Page: 52 / 353

3 - 22 S-80 • S-85 • S-80X Part No. 122985
Section 3 • Scheduled Maintenance Procedures February 2012
CHECKLIST B PROCEDURES
2 Be sure that all nuts and bolts are tight.
3 Inspect all welds for cracks.
4 Inspect for exhaust leaks; i.e., carbon buildup
around seams and joints.
5 Swing the engine pivot plate in towards the
machine.
6 Install the bolts that were just removed into the
original holes to secure the engine pivot plate.
Crushing hazard. Failure to install
the bolts into the engine pivot plate
to secure it from moving could
result in death or serious injury.
B-5
Inspect the Engine Air Filter -
Continental, Deutz and Perkins
Models
Note: Genie specifications require that this
procedure be performed every 250 hours or
quarterly, whichever comes first.
Maintaining the engine air filter in good condition is
essential to good engine performance and service
life. Failure to perform this procedure can lead to
poor engine performance and component damage.
Note: Perform this procedure with the engine off.
1 Locate the engine air filter assembly.
2 Release the latches from the air cleaner canister
end cap. Remove the end cap.
3 Remove the filter element.
4 Clean the inside of the canister and the end cap
with a damp cloth.
5 Inspect the air filter element. If needed, blow
from the inside out using low pressure dry
compressed air, or carefully tap out dust.
Replace the filter if needed.
6 Install the filter element.
7 Install the air filter canister end cap and secure
the end cap latches.
Note: Be sure the discharge valve is pointing down
when the cap is instaled.