Genie S-80, Service Manual, Page: 29 / 353

Part No. 122985 S-80 • S-85 • S-80X 2 - 9
Section 2 • Specifications February 2012
REV D
Hydraulic Hose and Fitting
Torque Specifications
Your machine is equipped with Parker Seal-Lok
®
fittings and hose ends. Genie specifications require
that fittings and hose ends be torqued to
specification when they are removed and installed
or when new hoses or fittings are installed.
SAE O-ring Boss Port
(tube fitting - installed into Aluminum)
SAE Dash size Torque
-4 14 ft-lbs / 18.9 Nm
-6 23 ft-lbs / 31.2 Nm
-8 36 ft-lbs / 48.8 Nm
-10 62 ft-lbs / 84.1 Nm
-12 84 ft-lbs / 113.9 Nm
-16 125 ft-lbs / 169.5 Nm
-20 151 ft-lbs / 204.7 Nm
-24 184 ft-lbs / 250 Nm
SAE O-ring Boss Port
(tube fitting - installed into Steel)
SAE Dash size Torque
-4 15 ft-lbs / 20.3 Nm
-6 35 ft-lbs / 47.5 Nm
-8 60 ft-lbs / 81.3 Nm
-10 100 ft-lbs / 135.6 Nm
-12 135 ft-lbs / 183 Nm
-16 200 ft-lbs / 271 Nm
-20 250 ft-lbs / 334 Nm
-24 305 ft-lbs / 414 Nm
Seal-Lok® fittings
1 Replace the O-ring. The O-ring must be replaced
anytime the seal has been broken. The O-ring
cannot be re-used if the fitting or hose end has
been tightened beyond finger tight.
Note: The O-rings used in the Parker Seal Lok®
fittings and hose ends are custom-size O-rings.
They are not standard SAE size O-rings. They are
available in the O-ring field service kit (Genie part
number 49612).
2 Lubricate the O-ring before installation.
3 Be sure that the face seal O-ring is seated and
retained properly.
4 Position the tube and nut squarely on the face
seal end of the fitting and tighten the nut finger
tight.
5 Tighten the nut or fitting to the appropriate
torque per given size as shown in the table.
6 Operate all machine functions and inspect the
hoses and fittings and related components to
confirm that there are no leaks.
Seal-Lok
®
Fittings
(hose end)
SAE Dash size Torque
-4 18 ft-lbs / 24.4 Nm
-6 30 ft-lbs / 40 Nm
-8 40 ft-lbs / 55 Nm
-10 60 ft-lbs / 80 Nm
-12 85 ft-lbs / 115 Nm
-16 110 ft-lbs / 150 Nm
-20 140 ft-lbs / 190 Nm
-24 180 ft-lbs / 245 Nm
SPECIFICATIONS