iSXblue/SXBlue II GNSS Series Technical Reference Manual
76
Baud Rates
4800
9600
19200
38400
57600*
When this command has been issued without the ‘,PORTy’ data field, the baud rate of the current port
will be changed accordingly. When the ‘,PORTy’ data field is specified (without the square brackets and
where ‘y‘ is A, B or C), a baud rate change will occur for the specified port. Note that the Bluetooth port
(PORTA) only supports 57600 baud (9600 baud for serial number below 0808A100) and can only be
modified by Geneq.
The iSXBlue/SXBlue II GNSS will reply with the following response:
$>
5.2.8
$JCONN
This command is used to create a virtual circuit between the A and B port, if needed. This allows you to
communicate through the iSXBlue/SXBlue II GNSS to the device on the opposite port.
The virtual circuit command has the following form:
$JCONN,p<CR><LF>
Where the connection type, ‘p’, may be one of the following:
p
Description
AB
Specify ‘AB’ in order to connect the A port (Bluetooth) to the B port (Serial)
X
Once a virtual circuit has been established, to remove the virtual circuit, specify ‘X’
in this command to return the current port to normal
5.2.9
$JDIFF
This command is used to change the differential mode of the iSXBlue/SXBlue II GNSS receiver.
The structure of this command follows:
$JDIFF,diff<CR><LF>
Where the differential mode variable, ‘diff’, has one of the following values:
