GE Moisture monitor series 3, Programming Manual

Page: 66 / 99

March 2008
3-38 Advanced Programming
Reconfiguring a Channel
for a New Sensor (cont.)
You can now do one of the following:
•
Configure the other channel by pressing
[NO]
until you return to the
Programming Menu. Then select the desired channel and repeat
the procedure.
•
Enter calibration data by pressing
[NO]
until you reach the
Programming Menu. Then refer to Entering Calibration Data for
New Probes/Sensors on page 3-39.
•
Refer to another section and perform a different procedure. Refer
to Figure 3-2 on page 3-48 and Figure 3-3 on page 3-49 to navigate
through the user program.
•
Exit by pressing
[RUN]
.
IMPORTANT:
You must configure a channel AND enter the
necessary calibration data for a sensor to work
properly.
Table 3-11: Probe Types and Configurations
Probe Type Configurations
Oxygen
N/A
% (Percent)
ppmv (Parts per Million by Volume)
Hygrometry
N/A
TF (Three-Function Probe)
Mxx (M Series Probe)
Kh (Constant Dew Point)
Temperature
N/A
TF (Three-Function Probe)
Mxx (M-Series)
Kt (Constant Temperature)
Pressure
N/A
TF (Three-Function Probe)
X1 (Auxiliary 1)
X2 (Auxiliary 2)
Kp (Constant Pressure)
Auxiliary 1
N/A
I (Current)
V (Voltage)
Auxiliary 2
N/A
I (Current)
V (Voltage)