GE Moisture monitor series 3, Programming Manual

Page: 32 / 99

March 2008
3-4 Advanced Programming
Setting Up the Recorders
The
MMS-3
has two recorder outputs (A and B) for each channel.
IMPORTANT:
Switch Blocks must be set to the appropriate
positions for output ranges (see
Setting the Switch
Blocks in Chapter 1 of the Service Manual) .
Press the
[PROG]
key to enter the user program.
Note:
If you have already entered the user program, see Figure 3-3
on page 3-49 to navigate to the Recorder Menu.
Be sure the number displayed in the upper right-hand corner of the
screen is the channel you want to program. If not, press the
[CHAN]
key to select the desired channel.
Enter Passcode: XXXX
Enter the passcode
.
Programming Menu 1
Use the arrow keys to move the
brackets to
RECORDER
and
_
[RECORDERS]
`
press
[YES]
.
Select Recorders 1 Use the arrow keys to move the
brackets to the desired recorder
[A] B
and press
[YES]
.
Select RCD Range 1 Use the arrow keys to move the
brackets to the desired recorder
[0-20mA] 4-20mA
`
range and press
[YES]
.
Select Mode 1
Use the arrow keys to move to
the desired measurement mode
and press
[YES]
. See Table 3-2 on
page 3-5 for a list of available
measurement modes.
O [H] T P Aux1
`