GCC Technologies S290LS Series, User Manual

Page: 59 / 148

232001410G(10)
55
Main Work Page
SmartCENTER Page
Navigating to this page:
Main Work Page
press
F3
SmartCENTER Page
Under SmartCENTER mode the job will begin after the system positions the carriage to the center
position between two or four points indicated by the user. The SmartCENTER mode has to be
enabled through the driver.
Enter SmartCENTER page by pressing the F3 button. You will be prompted to indicate and store
the position points. The positions can be indicated by moving the carriage by hand and pressing
enter to save the positions indicated by the red pointer. After all points are set, the carriage will
move to the center of the two entered points and the job will begin.
SmartCENTER Page
Relevant Buttons Function
F1 (Back) Back to previous page
F2 (Reset) Reset all saved positions
F4 (Save) Save current lens carriage position
ː
/
˒
Directional Manually adjust the Y-axis position of the laser carriage
Y
/
Z
Directional
Manually adjust the X-axis position of the laser carriage
Start / Stop Back to Main Work Page
Auto Focus Initiate the auto focus function
Ÿ
/
ź
Manual Focus Buttons Manually adjust the height of the work table (Z-axis)