GCC Technologies S290LS Series, User Manual

Page: 42 / 148

232001410G(10)
38
4.2 Graphics Software Setup
The LaserPro S290LS is compatible with graphics software that can output HPGL commands,
such as
CorelDRAW, Adobe Photoshop, AutoCAD, Illustrator etc.
Supported Graphic Software
• Photoshop
• CorelDRAW
• Illustrator
• AutoCAD
Other software such as EngraveLab and PhotoGrav may work with the LaserPro S290LS, but these
are not officially supported. Any software that can output to the LaserPro Print Driver should work.
NOTE
Support will not be offered, if you experience output problems with non-
supported graphics software.
4.2.1 Recommended Computer Configuration
The LaserPro S290LS operates under Windows operating systems and is designed to
work on a computer that meets the following minimum requirements.
Computer
͌
CPU – Pentium 90 (or equivalent) or greater
• RAM – 32 MB or higher
͌
HDD – 1.2 GB Hard Drive or greater
͌
SVGA – 15" Super VGA Monitor
͌
On Board Parallel Mode (Enabled from motherboard’s BIOS)
• SPP – Preferred Mode
• ECP – Cable (Less than 1.8 meters)
Software
• The LaserPro S290LS drivers are designed for Windows 2000, Window7 or other operating
systems developed subsequently.
4.2.2 Installation of the LaserPro Print Driver
1) Insert the LaserPro CD.
2) From the auto run menu, select
S290LS Æ Æ Æ Æ LaserPro Driver
to begin the LaserPro Print
Driver installation.
3) When the Add Printer Wizard menu comes up, click
Next
to continue.
4) At the Local or Network Printer page, select <
Local printer attached to this computer
>, then
click
Next
to continue.
5) At the Select a Printer Port page, select <
Use the following port
> and select the port that the
LaserPro S290LS will be attached to, then click
Next
to continue.