GCC Technologies S290LS Series, User Manual

Page: 33 / 148

232001410G(10)
29
4.1 Machine Setup
4.1.1 Powering Up the Machine
CAUTION
Make sure both the LaserPro S290LS and the computer are turned off before
connecting either to a power source.
1) Connect the male end of the power cord to a quality surge protector and then connect the
surge protector to a properly grounded outlet.
2) Do the same for the computer system.
3) Connect the female end of the power cord to the machine’s power cable inlet located on the
right side of machine.
NOTE
The LaserPro S290LS has been designed to automatically switch from 100-240 VAC.
TIP
Please adjust the LCD Display Screen’s Contrast
before plugging in the electrical cord of
your laser. LCD adjustment wheel is located underneath the control panel
4.1.2 Connecting the Computer
The LaserPro S290LS Series can communicate with a computer through a USB Port or LAN Port
connection interface. Regardless of the connection method chosen, you will need to connect the
respective connection cable from the LaserPro S290LS Series to your computer.
USB Connectivity:
Connect the included USB Port Cable to the USB Port on the right-hand
side of the LaserPro S290LS.
Ethernet Connectivity
:
Connect the LAN Cable in accessory to the LAN port on the right-
hand side of the laser system. Follow below instruction for ethernet connectivity setup..
NOTE
If you have purchased additional Optional Accessories for the LaserPro S290LS,
please refer to chapter VII for instructions on how to properly setup your optional
accessories. These should be setup prior to working with your LaserPro S290LS.