GCC Technologies S290LS Series, User Manual

Page: 132 / 148

232001410G(10)
128
The SmartGUARD 3-pin signal
jumper is positioned under the
blue connector of the Y motor
PCB.
4. Connect the wire from the SmartGUARD sensor board to the Y motor PCB.
5. Gently close the SmartLID top cover.
OPERATION MENU:
After optional SmartGUARD hardware installation, please enter the function menu on the control
panel to enable the SmartGUARD fire alarm. Note SmartGUARD fire alarm system is not a fire
extinguisher, but a fire detecting and alarm system.
SmartGUARD Enable/ Disable:
Press directional key (Left or Right) to enable the SmartGUARD device or disable it.
Sensitivity
烉
Press directional key (left or right) to set the sensitivity of SmartGUARD. There are five sensitivity
settings (1, 3, 5, 7, 9 seconds) that can be selected. Sensitivity defines the delay time from when
a fire is detected until the fire alarm alerts user, and automatically stop laser firing. For example,
if the sensor delay switch is set to the 3-second position, the SmartGUARD will start an alarm
and automatically stop laser firing after detecting a fire for 3 seconds.
Navigating to this page:
Main Work Page
Functions Page
press F4
Advanced Option Page
Select< Advanced
Options >from the
SmartGUARD Page
Select<SmartGUARD>
from the menu