GCC Technologies S290LS Series, User Manual

Page: 123 / 148

232001410G(10)
119
INSTALLATION / OPERATION (Cutting Box and Honeycomb Table):
1) Open the front pass-through door and lower the work table to the lowest possible position
through the LaserPro S290LS control panel.
2) Insert the cutting box and attached honeycomb table through the open front pass-through door
onto the work table, with the Fume Extraction opening facing towards the back end of the
LaserPro S290LS. Ensure the rear and left side of the cutting box is aligned to the edges of
the left and
right rulers on the work table.
3) Lift the honeycomb table to find the four screw holes at the bottom of the cutting box. With the
included thumbscrews, secure the cutting box to the work table and close the
honeycomb table.
4)
[OPTIONAL]
If you have an Fume Extraction system option installed, then you will need to
attach the Fume Extraction system’s pipe connector to the SmartBOX’s Fume Extraction
opening from the rear side. (For detailed instructions to setup the Fume Extraction system,
please see the FUME EXTRACTION UNIT section in section 7.1).
Congratulations, you are now ready to position your thin, flexible materials on top of your
honeycomb table / cutting box and commence your tasks.
INSTALLATION / OPERATION (Cutting Box and Material Support Stands):
1) In order to use the cutting box along with the material support stands, you must first remove
the honeycomb table from the cutting box. Before you position the cutting box in the
LaserPro S290LS, first loosen the screws that attach the hinges of the honeycomb table to
the cutting box.
2) Remove the honeycomb table. Please keep in mind the honeycomb table surface is fragile;
therefore, it is suggested to keep it in a safe place.
3) Open the front pass-through door and lower the work table to the lowest possible position
through the control panel.
4) Insert the cutting box through the open front pass-through door and place it onto the work
table, with the Fume Extraction opening facing towards the back end of the LaserPro S290LS.
Ensure the rear and left-hand side of the cutting box is aligned to the edges of the left and
right rulers on the work table.
5) Find the four screw holes at the bottom of the cutting box. With the included thumbscrews,
secure the cutting box to the work table.
6) On the front right hand side of the cutting table, there will be a metal guard, which must be
swiveled so that it is perpendicular to the front side of the cutting table (as shown in the
picture below). This allows the LaserPro S290LS to properly account for the extra height the
cutting table which adds to the cutting table.