GCC Technologies S290LS Series, User Manual

Page: 129 / 148

232001410G(10)
125
4) From the Paper Page, the first thing you must do is to check the Rotary Fixture. The Paper
Size options and Rotary Parameter will change to allow for proper input based on your rotary
attachment.
a) Under Paper Size, the X value represents the length of your working piece. Enter the
length of your work piece in this field.
b) U Under Paper Size, the Diameter value represents the diameter of your working piece (at
the position you wish to engrave). Enter the diameter of your work piece in this field.
Again remember the proper diameter value would be the diameter location on your work
piece you will be engraving.
c) Under Rotary Parameter, the Offset value represents distance from machine default
origin to where you would like to start laser job. The default value is zero.
5)
Go back to other pages of GCC Laser Print Driver to set up laser parameters like speed,
power, dpi etc. (refer to Chapter V of user manual of laser machine for details) and click “OK”
to print your design to laser machine for starting job
NOTE
The maximum diameter and length of the to-be-engraved object is 120 mm and 410 mm
respectively. Its maximum weight should not exceed 4kg.