GCC Technologies S290LS Series, User Manual

Page: 136 / 148

SmartLID Sliding Lock
8.2 Maintaining the Work table and Motion System
8.2.1 Accessing the Work Table and Motion System
It will be important to gain full access to the work table and motion system to properly clean and
maintain these areas. To do so, you will need to gain access by lifting the SmartLID. You can do this
via the following steps:
Opening the SmartLID:
1) The top lid of the machine can be lifted open by using the handles from the rear side of the
LaserPro S290LS. Lift the lid to the maximum (indicated by a small click) to engage the latch
(as shown in the picture below).
2) Manually lock the SmartLID via the two sliding locks found on each side of the metal support rails
by sliding them to the locked position (as shown in the picture below).
WARNING
Anytime you have the SmartLID open, always make sure you have properly engaged the
SmartLID manual locks on both sides of the metal support rails. Failure to do so may
pose a crush risk if any part of your body is within the vicinity of the work area.