GCC Technologies AFJ-24S, User Manual

Page: 62 / 234

AFJ-24S User Manual
62
Cancel Restore
Change: OK: ENTER
Sure to Restore
Change: OK: ENTER
Die/Kiss Cut:
Length: 9.0 / 0.2 mm
Die/Kiss Cut:
Force: 450 g 45 g
OFF
Change:
OK: ENTER
ON
Change:
OK: ENTER
Enabled, Disabled
Auto Unrolled Media
Select: OK: ENTER
Enabled, Disabled
IP Address set, Submask set,
Gateway set
Offline For System Setup
OverCut: 0.00~1.00mm with an
increment of 0.05mm
[TOOL SELECT]
1S: 72 F: 80 O:0.275 M
Select: OK: ENTER
OverCut: 0.00mm
Select: OK: ENTER
Set Smoothing Cut
Select: OK: ENTER
Set Tangential Mode
Select: OK: ENTER
Pouncing 0 mm
Select: OK: ENTER
Panel Setup
Select: OK: ENTER
Pouncing: 0~200mm with an
increment of 1mm
Factory Default ?
Select: OK: ENTER
Enabled, Disabled
Section Cut
Select: OK: ENTER
Rear Paper Sensor
Select: OK: ENTER
Enabled, Disabled
Adjust Paper
Select: OK: ENTER
[MISC]
Vacuum
Select: OK: ENTER
First Back To Origin
Select: OK: ENTER
DHCP
Select: OK: ENTER
IP Address
Select: OK: ENTER
MAC Address
00:CF:52:72:03:01
Enabled, Disabled
AAS Offset
Select: OK: ENTER
AAS Copy
Select: OK: ENTER
Enabled, Disabled
AAS Detect Mode
Select: OK: ENTER
5–1000mm with an increment of 5mm
Forward Direction, Auto Detection, Reverse Direction
±40mm with an increment of 0.5mm
Die/Kiss Cut: ON
Select: OK:ENTER