GCC Technologies AFJ-24S, User Manual

Page: 100 / 234

AFJ-24S User Manual
100
7.2 Operational Problems
Some mechanical problems or failure during operation will cause some problems. The error messages
shown on the LCM present the problem first, and followed by recommended actions. If the problem still
exists after the recommended actions have been done, have your cutting plotter serviced.
Error, Check Media
Or Drum or X Motor
This message indicates that there might be a
problem on the
X axis . Check if the drum is working
well and if the media is well loaded. Correct the
problem and re-power on to reboot system.
Error, Check Media
Or Y Motor
This message indicates that there might be an
obstruction to carriage relating to a problem on the
Y
axis . Correct the problem and re-power on to
reboot system
.
Error, Check Carriage
Sensor or VC Motor
This message indicates that the blade up/down sensor
malfunction. Re-power on to re-boot system. If the
problem still exists, find a serviceman.
Graph Was Clipped.
Data In Buffer
This message indicates that the cutting exceeds the
cutting limit. Reload larger media or re-scale the plot
to a smaller size; then press the key followed by the
display of LCM to continue.