G1000 NXi System Maintenance Manual
Page 369
King Air 300 Series
Revision 1
190-00716-N1
GDL 59 Wi-Fi Data Link Functional Check
This check verifies GDL 59 Wi-Fi Data Link interface is configured and is functional. This check
requires an operating and available wireless network to be within range of the aircraft.
NOTE
This check only verifies the data output from the G1000 equipment. Any
equipment/wiring added that is not part of the installation data will need
separate testing and verification not covered as part of this document.
1. Start the G1000 System in Normal Mode.
2. Using the large FMS knob, select the Aux page group on the MFD. Using the small FMS
knob, select the
Aux-Maintenance Wi-Fi Setup
page.
3. Press the
AVAIL
softkey on the MFD to display the available Wi-Fi networks.
4. Press the FMS knob on the GCU to activate the cursor and rotate the small FMS knob to
highlight the desired network in the
Available Networks
field.
5. Press the
Connect
softkey on the MFD to connect to the network. (Skip to step 11 if the
selected network is a non-secure network.)
6. If the selected network is a secure network, enter the pass code in the
Enter Passphrase
field in the
WPA Security Settings
pop-up window.
7. Press the
ENT
key on the GCU to accept the pass code, then press the
ENT
key on the
GCU again.
8. When the
Save Settings
pop-up window is displayed, press the
ENT
key on the GCU
keypad to select
Save Connection
.
9. Enter the airport identifier in the
Airport
field, then press the
ENT
key on the GCU to
accept the identifier.
10. With the
Connect
button highlighted, press the
ENT
key on the GCU to connect to the
network.
11. Press the
ENT
key on the GCU if the verification window “Are you sure you want to
connect?” is displayed.
12. Verify that the
Connection Status
field on the
Aux – Maintenance Wi-Fi Setup
page on
the MFD indicates
Connected
.
13. If no other service is to be performed, continue to the return-to-service checks in Section
GSR 56 Satellite Receiver Functional Check
1. Power up the PFD1 in configuration mode.
2. On the PFD1, select GDL page group using the large FMS knob.
3. Using the small FMS knob select the GSR56 Configuration page. Verify the page can be
displayed and information is available.
Summary of Contents for G1000 NXi
Page 112: ......
