MCT-MC
4.3
FDC MCT-MC
- 12 -
Installation
2.3.2 MC Process Loop Controls
One PID loop control is required for each process control loop in the system. The MC is compatible with both
the Future Design Controls P41, ¼ DIN control and the B42 board level control. Refer to the FDC controller
manual for the model of loop control being used for dimensions, appropriate mounting and installation
instructions.
For applications requiring frequent access to the process controllers, the panel mounted P41 series provides
direct access to the controllers. For applications where operator access to the controls is not required, or is
desired to be kept at a minimum, the B42 loop controls can be mounted directly inside of an enclosure. This
also reduces wiring concerns by eliminating the need to run the sensor, communication and control wiring for
each control to and from an enclosure door.
NOTE:
The MC requires firmware version V.22 or later in the P41/B42 loop control for proper manual event
operation. Early model controls can be used, but the manual event control will not function. Only
automatic ramp/soak program event control will be available.
Summary of Contents for MCT-MC 4.3
