Future Design MCT-MC 4.3, User Manual

Page: 161 / 186

MCT-MC
4.3
Appendix - 161 - FDC MCT-MC
*E2
Parameter
Value
Description
0 Hours and Minutes
1 Minutes and Seconds
2 Units/Minute
3 Units/Hour
*E3
Parameter
Value
Description
0 Hours and Minutes
1 Minutes and Seconds
*E4
Parameter
Value
Description
0 Ramp
1 Soak
2 Jump
3 End
*E5
Parameter
Value
Description
Bit0 Event 1
Bit1 Event 2
Bit2 Event 3
Bit3 – Bit15 Not Assigned
*E6
Parameter
Value
Description
0 Holdback Disabled
3 Deviation Band Holdback
*F
The unit PV means that the unit of the parameter is the same as the unit of PV (the loop configuration).
Use caution when loading an automatic program to the MC. You must insure that the decimal point scaling and units
of measurement in the program match the loop setting. Loading a program with a temperature set point of 80 will result
in a control temperature of 80°F if the loop control is in degrees Fahrenheit. However, if the loop control is set for
degrees Centigrade, it will result in a control temperature of 80°C (176°F).
Note:
The last step of an automatic program must be an end step. If the
last step is not an end step, the program will not run correctly and/or a
program download error will occur and the program will not operate.
Note: The available system events are based on the configuration of the
specific loop controller that the program is being downloaded to.