Furuno FR-10, Operator'S Manual

Page: 33 / 171

1. INSTALLATION & WIRING
1-17
3. Close the menu.
1.4.6 Advanced TT settings
The [TT Advanced] menu contains settings for the TT feature. This menu is protected
and adjustments/changes should only be made by a qualified FURUNO technician.
• [ QV Display ]: Set whether to show or hide the QV signal. Set to "On" to display the
QV signal, or set to "Off" to hide the QV signal.
• [ Echo Level ]: Set the echo level of the TT.
• [ Echo Size ]: Set the echo size of the TT.
• [ Land Size ]: Set the land size of the TT.
• [ Auto Acq. Corr. ]: Set the number of times the TT auto acquisition correlation.
• [ Auto Acq. Erase ]: Set the number of erasing the TT auto acquisition.
• [ Gate Size ]: Set the gate size of the TT.
• [ Filter Response ]: Setthe filter responsibility of the TT.
• [ Lost Count ]: Set the number of times the TT is lost.
• [ Target Vect Start ]: Sets the maximum tracking speed of the TT.
• [ Scan Time ]: Sets the vector time of TT.
• [ Start Scan ]: Set the scanning value of TT.
• [ Antenna Length ]: Sets the antenna length.
• [ TT Default ]: Resets all settings of TT to factory default.
1.4.7 SCX-20 settings
The items described in this section assume that your FR-10/12 is connected with an
SCX-20 on the same network. If a SCX-20 is not connected, the menu items cannot
be changed. For detailed instructions on these settings, see the operator’s manual for
the SCX-20.
• [ SBAS Mode ]: Set to [On] to use the SCX-20 for SBAS (Satellite Based Augmen-
tation System). Set to [Off] to ignore SBAS on SCX-20.
• [ Offset Heading ]: Apply an offset to the heading data received from the SCX-20.
• [ Offset Pitch ]: Apply an offset to the pitch data received from the SCX-20.
• [ Offset Roll ]: Apply an offset to the roll data received from the SCX-20.
• [ Smoothing SOG/COG ]: Apply time-based “buffer” to SOG/COG data received
from the SCX-20.
• [ Smoothing ROT ]: Apply time-based “buffer” to ROT data received from the SCX-
20.
• [ PGN Settings ]: View and adjust the baudrate for the PGN sentences output from
the SCX-20.
• [ Factory Reset ]: Restore the SCX-20 to factory default settings.
[Ship Speed Unit] kn, km/h, mph
Menu item Available options