Furuno FR-10, Operator'S Manual

Page: 34 / 171

1. INSTALLATION & WIRING
1-18
1.4.8 SCX-21 settings
The items described in this section assume that your FR-10/12 is connected with an
SCX-21 on the same network. If a SCX-21 is not connected, the menu items cannot
be changed. For detailed instructions on these settings, see the operator’s manual for
the SCX-21.
• [ Datum ]: Select the datum to use for SCX-21 positioning. The default setting is
[WGS84]. To manually select a datum other than [WGS84] or [WGS72], select [Oth-
er].
• [ Datum Number ]: Set the datum for the SCX-21 to use for positioning. This menu
item is only available when [Datum] is set to [Other].
• [ SBAS Mode ]: Set to [On] to use the SCX-21 for SBAS (Satellite Based Augmen-
tation System). Set to [Off] to ignore SCX-21’s SBAS.
• [ Offset HDG ]: Apply an offset to the heading data received from the SCX-21.
• [ Offset Pitch ]: Apply an offset to the pitch data received from the SCX-21.
• [ Offset Roll ]: Apply an offset to the roll data received from the SCX-21.
• [ Smoothing SOG/COG ]: Apply time-based “buffer” to SOG/COG data received
from the SCX-21.
• [ Smoothing ROT ]: Apply time-based “buffer” to ROT data received from the SCX-
21.
• [ Port1 Setting ]: Set the load rate and baudrate for output sentences from the SCX-
21’s Port1.
• [ Port2 Setting ]: Set the load rate and baudrate for output sentences from the SCX-
21’s Port2.
• [ Port3 Setting ]: Set the load rate and baudrate for output sentences from the SCX-
21’s Port3.
• [ Factory Reset ]: Restore the SCX-21 to factory default settings.
1.5 Optional Equipment
External buzzer
The external buzzer alerts you when targets violate the guard zone set. Connect the
buzzer to the display unit as shown below, using the external buzzer installation kit.
External Buzzer Installation Kit
Type: OP03-21, Code No.: 000-030-097
Name Type Code No. Qty Remarks
1 Buzzer PKB42SWH2940 000-153-221-10 1 Connector at both ends
2 Cable Tie CV-70N 000-162-185-10 5
3 Heat Shrink Tube 3 × 0.25 BLK — 1
4 Double-sided Tape 25
×
25
×
T0.91MM 000-173-188-10 1 25 m
×
25 mm