Furuno FR-10, Operator'S Manual

Page: 115 / 171

5. AIS OPERATION
5-5
5. Press the MENU key to close the menu.
5.6 Display Range
You can set the AIS system to show only those AIS targets within the range you set.
The setting range differs depending on the connected radar sensor. Actual range de-
pends on the AIS Transponder. If the target sorting method is selected to [Range], the
target data within the range set here is transmitted to this radar.
1. Press the MENU key to open the menu.
2. Select [AIS], then press the ENTER key.
3. Select [Range], then press the ENTER key.
4. Set the display range, then press the ENTER key.
5. Press the MENU key to close the menu.
Note: The unit of measurement for range is NM.
5.7 How to Display the Targets within a Specific Sec-
tor
You can display AIS targets only within a specific sector. If the target sorting method
is selected to [Sector], the target data within the sector are shown on the display unit.
1. Press the MENU key to open the menu.
2. Select [AIS], then press the ENTER key.
3. Select [Sector Start], then press the ENTER key.
4. Set the start point for the sector, then press the ENTER key.
5. Select [Sector End], then press the ENTER key.
6. Set the end point for the sector, then press the ENTER key.
7. Press the MENU key to close the menu.
5.8 Number of Targets to Display
You can select the maximum number of AIS targets to display. The setting value is 10
to 100. When the screen becomes cluttered with AIS targets, you can limit the number
of AIS targets to show. Targets are selected and displayed according to sort method.
(see section 5.5).
1. Press the MENU key to open the menu.
2. Select [AIS], then press the ENTER key.
3. Select [Number of Targets], then press the ENTER key.
4. Select the number of targets to display, then press the ENTER key.
5. Press the MENU key to close the menu.