Furuno FR-10, Operator'S Manual

Page: 79 / 171

2. OPERATION
2-43
9. Select [Barge Arrangement], then press the ENTER key.
10. [Column1(PORT)] is highlighted by the cursor. Press the ENTER key.
1) Set the number of barges in the port column.
2) Set the quantities of barges in the selected column (max: 9), press the ENTER
key.
The rectangles on the left side of the [Barge Arrangement] window will fill up
according to the value you set.
3) After setting all required columns, select [Close This Window], then press the
ENTER key.
11. Press the MENU key to close the menu.
2.33 Watchman
The Watchman sounds the buzzer to tell the operator to check the radar display. The
radar transmits for one minute and then goes into standby for the selected time inter-
val. If the target alarm is active and a target is found in the alarm zone, Watchman is
cancelled, and the radar transmits continuously.
In standby, the timer near the <WATCH> label at the center of the screen counts down
the remaining time until the transmission. When the set time interval has passed, the
audio alarm sounds, the timer disappears and the radar transmits for one minute. After
one minute, the audio alarm sounds and the watch alarm timer again begins the count-
down sequence.
ST-BY
5,10 or 20 min.
Tx
1 min.
Watchman
starts
*
* Beep sounds just before radar transmits
or goes into standby.
Tx
*
5,10 or 20 min.
1 min.
* *
ST-BY