Furuno FR-10, Operator'S Manual

Page: 30 / 171

1. INSTALLATION & WIRING
1-14
5. Press  or  to set the value measured at the above step 2. Check that the target
appears on the heading line.
Note: Increasing the value causes the echo to move counterclockwise. Decreas-
ing the value causes the echo to move clockwise.
6. Press the ENTER key to finish.
1.4.3 How to setup main/sub radar displays
Up to three display units can be connected to the same antenna unit. You can set the
[Radar Type] and [Sub Type] for each display unit.
1. Open the [Installation] menu and select [Main/Sub Radar].
2. Select [Radar No.], then press the ENTER key. A drop-down selection menu ap-
pears.
3. Select the number of the radar whose type/sub type you want to change, then
press the ENTER key.
4. Select [Radar Type], then press the ENTER key. A drop-down selection menu ap-
pears.
5. Select the type you want to assign, then press the ENTER key.
• [Main] : Sets the selected display unit as a main-display.
• [Sub1/2] : Sets the selected display unit as a sub-display.
6. Select [Sub Type], then press the ENTER key.
7. Select the desired type, then press the ENTER key.
• [Independent] : Settings changed on this unit are only applied to this unit. This
setting also activates the dual-range mode on antenna units all compatible an-
tenna units (excluding . For , type is automatically set to
[Interlocked] and cannot be changed).
• [Interlocked] : Settings changed on the main display are reflected to this dis-
play unit.