Fukuda Denshi Dynascope 8000 Series, Maintenance Manual

Page: 49 / 154

1-9
Chapter 1 Installation of the Unit Installing the Lithium-Ion Battery Pack (BTO-008)
Equipotential Grounding
When connecting multiple devices, electrical potential difference may be generated between the devices. This may
result in electric shock to the patient connected to these devices.Pay special attention for use in operating room, ICU,
CCU, cardiac catheter laboratory, and cardiovascular X-ray room. To avoid such electrical potential difference, use
the ground cable to connect each device's potential equalization terminal to the same ground terminal. This is called
equipotential grounding.
The ground cable is a connector which can be connected/disconnected manually without using tools.
Installing the Lithium-Ion Battery Pack (BTO-008)
WARNING

When lifting this equipment, hold it by the handle or the bottom part of the main unit.

When replacing the battery while monitoring, make sure to connect the AC Unit to supply
power by the power cable.
1
Place the DS-8007 main unit upright on a table or other stable surface.When replacing the battery while
monitoring, connect the AC Unit (DSA-81).
NOTE

Secure sufficient workspace for installation.
2
Open the battery cover on the DS-8007 main unit. If the battery is already installed, release the battery lock
lever and remove the battery.
NOTE

Hold the battery lock lever when removing the battery.

Do not apply excessive force when sliding.
1 Battery Cover
2 Battery Lock Lever
1
2