Fukuda Denshi Dynascope 8000 Series, Maintenance Manual

Page: 121 / 154

6-9
Chapter 6 Setup Item/Default Value Setup Item
NOTE

For the item with *mark, the setting is backed up on the AC Unit (DSA-81). Performing F-
start (turning the power ON with the rotary switch set to F) will not initialize the setting.
The settings may change if the AC Unit (DSA-81) is replaced.

Initial Settings (System)
AC Unit
Item Description Default Backup
Communicati
on Setup
*
COM OFF, PC Comm., BIS, Barcode Reader,
Magnetic Card Reader, PC Comm. (DS-5000) OFF Yes
Status II OFF, SV-300, SERVO-i/s, SERVO-U/n/air,
Velia, Ultra, Astral, PB, Evita, BIS OFF Yes
Network
Item Description Default Backup
Printer* Network Printer OFF, DS-LAN OFF Yes
Central Monitor 001 to 016 001 Yes
Status Output
Item Description Default Backup
Alarm Output
Setup* Alarm to Output OFF, APNEA, Level H, Level H,M, Level H,M,L OFF Yes
Status II Positive Logic, Negative Logic, Pulse Negative Logic Yes
Item Description Default Backup
DS-LAN* DS-LAN Setup DS-LANII (10Mbps) , DA-LANIII
(100Mbps) DA-LANIII (100Mbps) Yes
Room ID 3 alphanumeric characters BED Yes
Bed ID 3 numerics 000 Yes
DS-LAN Pat. ID
Transmission Start
Position 1st to 20th character 1st character Yes
Synchronize
Hemodynamic Data
with the Central
Monitor ON, OFF OFF Yes
CO
2
(mmHg) Upper
Limit of
Transmission
No limit, 99mmHg 99mmHg Yes
Telemeter Usage ON, OFF ON Yes
Channel 1001 to 1080, 2001 to 2120
3001 to 3040, 4001 to 4080
5001 to 5080, 6001 to 6080 Telemetry Transmission
Depends on the telemetry
transmitter module Yes
Group 00 to 63 00 Yes
Transmitting
Waveform ECG1(ECG1, RESP, CO
2
, BP1, BP2,
SpO
2
), ECG2 (ECG1. ECG2. RESP/
CO
2
, BP1, SpO
2
)
ECG1(ECG1, RESP,
CO
2
, BP1, BP2, SpO
2
)
Yes
CO
2
(mmHg) Upper
Limit of
Transmission
No limit, 99mmHg 99mmHg Yes
Other AC Filter 50Hz, 60Hz 50 Hz Yes
Search Patient ID* Enable, Disable Disable Yes