Fukuda Denshi Dynascope 8000 Series, Maintenance Manual

Page: 135 / 154

8-3
Chapter 8 Cleaning/Disinfecting/Storing Cleaning the Equipment and Sensors
2
Wipe the touch panel using a cleaning cloth.
3
Press again the [Key Lock] key for more than 2 seconds.

The message will disappear, and the key locked condition will be canceled.
Housing

Cleaning
Wipe using a tightly squeezed cloth saturated with diluted neutral detergent. Then wipe with a dry cloth.

Disinfection
Wipe with a cloth dampened with one of the following chemicals. Then, wipe off with dry cloth.
CAUTION

Clean the equipment frequently so stains can be removed easily.

To prevent injury, it is recommended to wear gloves when cleaning the equipment.

When cleaning or disinfecting, do not allow chemical solution to enter the equipment or
connectors.

Do not use organic solvents, thinner, toluene or benzene to avoid damaging the resin case.

Do not polish the equipment with abrasive, chemical cleaner, alkaline or acidic detergent.
Otherwise, the surface resin or paint coating may be damaged, resulting in discoloration,
scratches, and other problems.

For the precautions for storing and handling the chemicals, refer to the instruction manual
for the respective chemical.
NIBP Cuff and Air Hose
To clean the cloth bag of the cuff, remove the rubber bag and wash it using neutral detergent.Make sure that the cuff
is dry before placing back the rubber bag inside.
For procedure to clean/disinfect the reusable cuff, refer to the instruction manual for the respective cuff.
Do not reuse/resterilize the disposable cuff.
Usable Cloth:
*Soft cloth (cotton)
*Soft non-woven cloth (pulp, rayon, polyethylene, etc.)
Chemicals:
*Glutaral 2%
*Alcohol (ethanol, isopropyl alcohol for disinfection)
*Benzalkonium Chloride 0.2%
*Benzethonium Chloride 0.2%
*Alkyldiaminoethylglycine Hydrochloride 0.5%
Usable Cloth:
*Soft cloth (cotton)
*Soft non-woven cloth (pulp, rayon, polyethylene, etc.)