Fukuda Denshi Dynascope 8000 Series, Maintenance Manual

Page: 96 / 154

5-10
Chapter 5 Initial Settings Measurement Related Setup
3
The measurement source of BP/NIBP mean value can be selected from waveform or calculation.

[Calc.]: Calculates the mean BP from the following calculation. Mean BP = (Systolic BP + Diastolic BP x 2) /3

[Wave]: In case of NIBP, maximum amplitude of oscillograph will be the mean value (MAP). In case of BP,
the following measurement will be performed.
NOTE

The NIBP specification stated on "Chapter 14 Specification" is based on the validation
when [Wave] is selected.
4
Set the "Arrhythmia Analysis Filter".

[Disp. Waveform]: The filter selected on "Admit/Discharge" menu or "ECG" setup menu will be set.

[Fixed]: The filter will be fixed to 0.5 Hz to 40 Hz.
NOTE

When [Disp. Waveform] is selected, the filter will be set according to the selection on
[Menu > Parameter > ECG]. If [Diag.] is selected, the filter will be 0.5 Hz to 40 Hz which
is the same with [Fixed].
5
Set the "Synchronized Mark/Tone".When [Auto] is selected for "Synchronized Mark/Tone", the priority of the
synchronizing parameter can be set.

[ECG]: The synchronizing priority will be set in the order of ECG>SpO
2
>BP. The synchronized tone will set
to [ON].

[SpO
2
]: The synchronizing priority will be set in the order of SpO
2
>ECG>BP. The synchronized tone will be
set to [ON].
6
Set the display priority of the parameter to be displayed inside the HR/PR numeric data box.
This priority setting will be applied when [Auto] is selected for "HR/PR", or when [HR/PR] user key is used to
switch the HR/PR source.
Select the priority order from the dropdown list.
For example, if [ECG/SpO
2
/BP] is selected, HR/PR source will be set in the priority of ECG>SpO
2
>BP.
7
Set the "Catheter Manufacturer for CC Input".Press one of the keys, and enter the manufacturer name on the
displayed window. (Max. 8 characters)
Example of BP Measurement
1: Systolic BP
2: HR interval
3: Mean BP (MEAN)
4: Diastolic BP